![]() ![]() ![]() Most slicers have this feature built-in, but Cura seems to be the rare exception that lacks direct machine commands (despite otherwise being a complete printing solution). Once you understand it, auto bed leveling makes perfect sense, but most of the resources found online are either needlessly complicated or just plain wrong.īefore we can get started, we first need to grab some software that can communicate with the 3D Printer over USB. Most of this guide will just reiterate the information he provides in the video, but several personal observations have been added as well. Go figure, it took all of 5 minutes and my auto bed leveling sensor was near perfect. Rather than try to adjust the sensor’s position by hand, he used a series of g-code commands to calibrate it with ease. At that point, none of the instructions I had found worked out and print jobs would embed plastic in to the build surface, needing to be replaced several times in the process.Īs I was getting tired of buying more Build Tak stickers every other week, I went looking once again and stumbled across a video from 3D Maker Noob that seemed promising. This was my first time using auto bed leveling and I was still testing out various methods to calibrate the sensor, where I decided to leave this for a separate guide. ![]() Several months ago I wrote an in-depth article on How to Setup Auto Bed Leveling which covered the entire process from start to finish… at least almost. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |